Forum

General discussion about Bf Bot Manager v3 software for Betfair, Betdaq and Matchbook betting exchanges
By fumusic
#18935
Hi Rade,
I developed my own dutching strategy using the greyhound dutching example as you suggested.
However, on the simulation run today, no bets were fired.
According to the reports tab, the market does not satisfy time to bet rule. (see attachment)
Untitled.jpg
Untitled.jpg (367.1 KiB) Viewed 12964 times
The time to bet rule is actually the unchanged setting used in the example strategy.
Please advise.
User avatar
By BfBotManager
#18936
Hi fumusic,

At your screenshot there is column "Time of report", it shows that those reports were generated at 17:05 and race was set to start at 17:00. Time of bet by your settings is satisfied from 10 seconds before start time, that is from 16:59:50 until race goes in play.

Please export your strategy and we will check it, probably some other rule is causing you problems. You can test this easily in simulation mode by removing time to bet rule.

Regards,
Rade
User avatar
By BfBotManager
#18938
Hi John,

Just tested this and strategy placed bets in simulation mode, so it is ok. Make sure you test it too in simulation mode to ensure it works like you want it to.

Regards,
Rade
By fumusic
#18939
Hi Rade,
Yes, I also tested this in simulation mode yesterday and no bets were fired.
Why am I getting the not satisfied statuses for each race?
However, I will leave the bot running in simulation mode again today to see if it works.
If I do get the same problem which tabs do you want me to take screen shots of for you to examine?
User avatar
By BfBotManager
#18940
Hi John,

I removed "Markets filter" so that strategy is able to bet on all races and it placed bets. Take a look:
https://www.screencast.com/t/Eqmex8gAj

This means that it is just issue with your filter setting and finding right races that will satisfy all your rules. For test purpose just remove Markets filter and bets should be placed when time to bet and all other rules are satisfied. If bets get placed then it will mean that you loaded markets properly and that they are being monitored, so then it leaves you with issue of your markets filter settings.

Regards,
Rade