Page 1 of 1

Selection Conditions 'Min/Max Odds'

Posted: Mon Jul 16, 2018 9:33 am
by Wrighty
Hi everyone,

I have a strategy that I am currently monitoring which seems to be executing lay bets on odds higher than I wish despite using the current settings;

Strat - Lay 3rd favourite within min/max criteria, aslong as 1st favourite is within min/max criteria

Selection conditions;
- Min/Max selection (LAY price for favourite position 1 must be within the price range of 1.01 - 4)
- Min/Max selection (LAY price for favourite position 3 must be within the price range of 5.5 - 9)
- Bet type (runner with favourite position 3 is LAY only 1 bet allowed per favourite position)

However currently it seems some bets are executing with the LAY on 3rd Favourite at 15.0 odds which doesnt make sense.

Any help would be much appreciated, I am sure I am using the wrong selection conditions however I cant figure it out.

Cheers,
Wrighty

Re: Selection Conditions 'Min/Max Odds'

Posted: Mon Jul 16, 2018 10:54 am
by BfBotManager
Hi Wrighty,

Please post screenshot of those bets and export your strategy that made those bets so that we can check its settings.

Regards,
Rade

Re: Selection Conditions 'Min/Max Odds'

Posted: Mon Jul 16, 2018 11:39 am
by Wrighty
Strategy Attached

Re: Selection Conditions 'Min/Max Odds'

Posted: Mon Jul 16, 2018 11:40 am
by Wrighty
Image of bet

Re: Selection Conditions 'Min/Max Odds'

Posted: Mon Jul 16, 2018 11:48 am
by BfBotManager
Hi Wrighty,

You are checking price range of "RUNNER by position" 3 and you are betting on "FAVORITE by position" 3. Those are two different runners. Take a look at your settings:
https://www.screencast.com/t/MAiUvo0sUd1o

Rule "Min/max selection price" that is set to check price of 1st favorite is useless here as you are not betting on first favorite. If you want to make sure that first favorite is in this price range then you should use "Market conditions->Min/max REQUIRED price for selection" rule. Please see manual for details on each rule:
https://www.bfbotmanager.com/documents/ ... manual.pdf

Please use simulation mode to test your settings. Once that is working well then use real mode with small stakes to test your settings again.

Regards,
Rade