Page 1 of 1
country filter
Posted: Tue Jul 21, 2015 7:26 am
by dazzer979
Hey
i want to just trade with certain stragys on dogs in aus and nzl, but the region and coucntry filter stops it from betting on anything as in the report it say country filter for reason not bet. ive tried country filter on its own and region filter, any other ways to achieve this?
thanks as always
Re: country filter
Posted: Tue Jul 21, 2015 8:50 am
by BfBotManager
Hi dazzer979,
Please export your strategy and post it here so that we can check it. Make sure you loaded those markets to markets grid.
Regards,
Rade
Re: country filter
Posted: Wed Jul 22, 2015 8:34 pm
by dazzer979
here it is (2.98 KiB) Downloaded 970 times
Re: country filter
Posted: Thu Jul 23, 2015 2:37 pm
by BfBotManager
Hi dazzer979,
Your country filter is set to allow betting on markets from Austria only. I suggest you remove this country filter and instead use "Region" filter, it will be easier to set it.
Your stake is 0.01, but you are using liability, which means that calculated stake will be smaller than 0.01. This is wrong. Stake must be at least 0.01. I suggest you remove "Liability or amount to win" condition.
Then try again in simulation mode and see if it works like you want it to. For testing purposes I suggest you remove both "Selections filters" that you have set.
Regards,
Rade
Re: country filter
Posted: Sat Jul 25, 2015 2:03 pm
by dazzer979
Hey, i removed the country filter and done region, also removed the liabilty setting, still not wanting to bet on anything?
Re: country filter
Posted: Sat Jul 25, 2015 2:47 pm
by BfBotManager
Hi dazzer979,
You are betting on Place market, so overrounds might not be correctly set. Try removing overrounds and add "Back/Lay Ratio" at Selection conditions tab instead and set it to 15%.
Then bets should be placed.
Regards,
Rade